Half shaft install issue "I think"

[z06psi]

O.k. I want some to verify that the half shaft on the passenger side sits a little further out of the diff then the drivers side.

Here is a pic of the passenger side.

Everything bolts up but I want to make sure before I set the car down. It will not go in any further than this. Yes it catches a couple of times and "knocks in" till it get to this point.

I also want to make sure that the skinnier one goes in the passenger side and the fatter one goes in the drivers side. Thanks in advance.

Sponsored

 

[z06psi]

Anyone?

Sent from my SM-N910V using Tapatalk

 

[GTBOB]

Maybe this info can help:

Passenger side axle

 

[GTBOB]

Driver's side axle

 

[z06psi]

Driver's side spline is longer. Swapped sides and all is well. Had to drink a beer to think about it.

 

[ETCH]

did that yourself... impressive. i would love to see a video on the process. i ea going to take mine to a shop, but i would love to know the process to see if i would tackle it. ive done a lot of the work myself on mine...

 

[z06psi]

I am doing everything in my sig over this weekend and the next. I am on the front now and it is going smoothly. I love this exhaust sound. I think the quad tips are even deeper in sound. You can go over to my build thread. I will update a bunch of stuff over there.

 

[Crush]

did you go with the 800 or 1400?

 

[z06psi]

800.

700rwhp is as far as I am going

Sent from my SM-N910V using Tapatalk

 

[Super Werty]

Did you by any chance weigh them? Curious of the weight difference between them and oem

 

[z06psi]

No I didn't. Some one else did though before they installed them. It is significant though.

 

[jaja6009]

Thanks, useful info. I love pioneers that make these installs easier for the rest of us.

 

[z06psi]

Thanks, useful info. I love pioneers that make these installs easier for the rest of us.

Go over to my build thread. There is some more over there.

http://www.mustang6g.com/forums/showthread.php?t=26612&page=4

 

[Volstang]

How difficult of a job is it to swap half shafts in your garage on jack stands?

 

[z06psi]

Very easy actually. Once you get the rear knuckle off they slide out. Getting the knuckle off is 3 bolts once you get the brakes off.

Sponsored