XCRN
Well-Known Member
- Joined
- May 23, 2018
- Threads
- 16
- Messages
- 92
- Reaction score
- 50
- Location
- Springfield OH
- Vehicle(s)
- 2016 Mustang
- Thread starter
- #1
I have for sale just about everything needed to do a Shelby GT350 brake swap on the 15 and newer S550 Mustang. This will include custom Powder coated and re-sealed calipers that were done by me, some flaws in the finish but not too bad by any means. Front and rear knuckles with parking brake mechanisms. Front control arms from a Shelby. OP Mustang front caliper mounting studs. And parking brake cables.
So all that is really needed is brake pads, parking brake hardware, and pad retainers, rotors. Supposedly GT350 tie rods are needed to connect to the knuckles.
I will not separate, to be sold as whole only. I am asking $1600 OBO, would consider vehicle trades. Willing to ship or deliver for extra.
So all that is really needed is brake pads, parking brake hardware, and pad retainers, rotors. Supposedly GT350 tie rods are needed to connect to the knuckles.
I will not separate, to be sold as whole only. I am asking $1600 OBO, would consider vehicle trades. Willing to ship or deliver for extra.
Sponsored
Last edited: