Forscan and the 2020 GT500

[bent98]

Yes, this is the same as what I did.



I was running 315/30/21 fronts and 325/30/21 rears before I got the wide body SE and went back to stock front and 345/30/20 rears.

What was width of rim and offset ?

Sponsored

 

[Jmeo]

What was width of rim and offset ?

The 21’s were 10” front and 11” rear. I do not have the offset information. They were Signature SV301

 

[bent98]

The 21’s were 10” front and 11” rear. I do not have the offset information. They were Signature SV301

At the time what front springs did you have in the car? Roy you remember what was the height from floor to fender ?

 

[Jmeo]

At the time what front springs did you have in the car? Roy you remember what was the height from floor to fender ?

I ran both stock springs, then CFTP springs but I do not have any measurements.

 

[Wolvee]

Every time I see this thread is reminds me of my friend who used forscan on his F150 to adjust wheel diameter so he could scam his Lease. lol. Nobody cares about parking lights and seat belt dingers.

 

[bent98]

so if i go with a 29inch talk 305/45/18 tire. So circumference = 2299mm.

Is that correct?

 

[SYKOTIK]

Bumping this thread back up. I'd like to make some Forscan changes to my car.

1. Double honk disable (covered above)
2. DRL stripes at full brightness with parking lights and headlights on
3. Front turn signals and marker lights on with DRLs
4. Security Mode (can't shift out of Park if fob is not in car)

Anybody have any info on that? I've use Forscan on my 2018 Raptor and 2019 Super Duty and folks were able to make changes like this. Just curious if anyone has figured it out yet for the GT500.

bump on this again any one got some codes they wana share..
also looking for seat belt chime and reminder

 

[bent98]

Anyone figure out how to move the TPMS psi low tire warning.

This guy did it on his F150 need GT500 location

 

[marklboris]

Anyone figure out how to move the TPMS psi low tire warning.

This guy did it on his F150 need GT500 location

In FORScan in the configuration and programming mode, select BdyCM (NOT As Built format) and scroll down to TPM - Placard Front, psi, TMP - Placard, psi and change the psi to what you want.

Sponsored