Dyno tune L&M intake cams with Gen2-R

[09jsw]

As title says I finally got my dyno tune for my Gen 2-R with 82mm. Mods are vmp Twin67, L&M intake cams, ARH 1-7/8 catless and a JLT intake on 93 pump gas. Dyno I used is very consistent and the same I’ve used the whole time I’ve owned my car. Last setup was ported Cj with the cams and same tb but on e85 made 478 sae

New setup is a hair under 688/555 sae smoothing 5

Sponsored

 

[gimmie11s]

Congrats! How much boost? What pulley combo?

 

[09jsw]

Congrats! How much boost? What pulley combo?

Thanks. I want to say it’s reading 8-8.5 psi. Actual boost isn’t really helpful because it can be lower or higher depending on tune and mods. It’s the 82mm pulley with stock sized ATI balancer.

 

[Boduke0220]

Strong numbers

 

[cookymunster_gt]

Thanks. I want to say it’s reading 8-8.5 psi. Actual boost isn’t really helpful because it can be lower or higher depending on tune and mods. It’s the 82mm pulley with stock sized ATI balancer.

Thats stout for 8-8.5 psi considering cars with out cams make 670 on 10-11 psi

 

[olaosunt]

Nice .
Do you by chance have a pull before the cams to compare?

 

[09jsw]

Nice .
Do you by chance have a pull before the cams to compare?

Sorry I don’t. I’ve had the cams in for a few years now and before the blower went on.

Sponsored