Dyno results

[bodam]

Don't want to hijack his thread [emoji51]


Sent from my iPhone using Tapatalk

Sponsored

 

[Moddiction]

Baseline was super low for some reason there. After number is right on point for intake and tune though. STD correction reads a bit high but SAE would be around 400whp most likely.

 

[Sasuketr]

Nice numbers! It all depends on the dyno, even though it is a dyno jet, i have seen some dyno jets reading lower than a mustang dyno.

I am also curious to see the results with a lund FF tune and steeda intake with the car on 93 Octane!

 

[bodam]

Lund tuned my 2011, and I won't use him again

I'll stick with Leading Edge. Erick treats me right. [emoji1303]


Sent from my iPhone using Tapatalk

 

[zaquhree]

Run it at the track. I made less HP than you OP but went faster than most

 

[bodam]

Not sure if I'll track his one. That's why I went crazy with the one lol.


Sent from my iPhone using Tapatalk

 

[craigsix]

Yeah that was with a Steeda CAI and Steeda tune. Going to try Lund because I was expecting a little more.

what trans & gears?

 

[Jeff's FRC]

You're tuned and still have a speed limiter?

 

[Hector247]

what trans & gears?

3.31

 

[Hector247]

Run it at the track. I made less HP than you OP but went faster than most

That makes me feel a little better. I will try to get out to a track in the next couple weeks.

 

[Hector247]

You're tuned and still have a speed limiter?

Yeah, they said it cut off at 160. I'm guessing Steeda limits there tunes to 160

 

[V8EATR]

Bodam, look at the correction factors. The 410 run was a 104% correction, the 361 was 96%, that's a difference of 29hp. That's why SAE is used, to avoid that variance.

 

[Moddiction]

Yup. Standard is used to make customers feel better about numbers normally it seems.

Sponsored