Created gt350 fender badge inserts

[shelbyzim]

Vinyl inserts for the GT350 side badge grooves. Takes a little patience to apply - but in the end I think it looks cool.

Available at www.zimcraft.ca

Sponsored

 

[MikeMM]

I think it looks pretty cool.

 

[TDC]

Reminds me of my 1968 firebird emblems with the bright outline around colored letters. I like it and would think for certain colors would be a nice touch.

 

[shelbyzim]

Reminds me of my 1968 firebird emblems with the bright outline around colored letters. I like it and would think for certain colors would be a nice touch.

They can be created in many colors, I have a lot of other colored vinyls.

 

[Wine dude]

They do look nice, I tried installing them from a vendor and your right they take a bit of patience to get them on correctly, I was rushing and wound up screwing it up horribly, will need to get another set and try again. Hopefully since are recessed in the letters and number grooves they won’t peel out when the car gets washed

 

[LFG_Cory]

I ordered red inserts for the side badges, rear badges and the splitter. Also ordered the chassis number decal for the left front fender.

Looking forward to getting them.

 

[dstanky]

Are you selling these?

 

[sagonzal2000]

They do look nice, I tried installing them from a vendor and your right they take a bit of patience to get them on correctly, I was rushing and wound up screwing it up horribly, will need to get another set and try again. Hopefully since are recessed in the letters and number grooves they won’t peel out when the car gets washed

I got mine from bemarofilms.com is that where you got yours from ? They look pretty cool

 

[Wine dude]

I have had 2 sets from different vendors, the first I screwed up badly, the second set went on fine looked great, car wash a week later and they vanished, will try one more time with the bemaro ones once they arrive.

 

[ryanr24]

Same mine came off first time I washed the car, messaged zim have not heard back guess I learned my lesson should of just stick with bemaro

 

[mavisky]

 

[sagonzal2000]

I have had 2 sets from different vendors, the first I screwed up badly, the second set went on fine looked great, car wash a week later and they vanished, will try one more time with the bemaro ones once they arrive.

The Bemaro ones have held up for me after 5-6 car washes with no peeling or fading . He’s got tons more colors and products .
www.bemarofilms.com

 

[tedj101]

I made some vinyl inserts to go into the GT350 side badge grooves. Takes a little patience to apply - but in the end I think it looks cool. What do you guys think?

I like it!

 

[sagonzal2000]

Looks good - I got mine at www.bemarofilms.com

He’s got about 10-12 different colors. No peeling , fading after 5 car washes . Any issues and he’ll replace them. He also does the Shelby badge vinyl overlays in different colors including the US flag and camouflage and fender vent overlays (I ordered the red ones).check them out.. I
Last photo is of vinyl caliper overlays and center caps with Shelby cobra

 

[GPG]

I ordered red inserts for the side badges, rear badges and the splitter. Also ordered the chassis number decal for the left front fender.

Looking forward to getting them.

Where did you order the red decals from?

Sponsored