What 3m tape and thickness did you use? I ordered the below tapes to try. I figure the thinner the better the fitment. I’m going to atleast put the better tape at top above and around the gauges on my GT500. I installed the 1st kit and had trouble removing it. They are sending replacement but wanna make sure I get a better fitment this time.Knee Pads are installed but, I am not happy with the double sided tape the provided. The tape is not 3M. For as much as they are charging for the pieces which, are beautiful and provide a 98% fitment, they will not receive a 5 start rating from me. I give the product for Forgitec , 4.5 starts. Looks great but, for the price they need to provide a better execution. I will be holding off installing the console until I replace the tape provided. I will also be reinstalling the knee pads as the tape is not holding as it should.
Forgitec 4.5 stars - For the cost, they should have come with 3M tape. Fitment is about 98%. There are a couple of gaps here and there that aren't noticeable but, I know they are there. There is also no way I will install the console in place and I will need to remove it in order to insure the overlay sits perfectly. I will also be setting up the tape so, I can pull the tape off in stages in order to insure the tape sets up properly and pulls the overlay down into place.
How’d it install with better tape?
When I entered this code it took off 10%, not 20% just a heads up
That's SERIOUS carbon!!!Thought I'd post some more photos of my carboned out '15. I feel like I'm going through withdrawals since I have been without it for two years now. These were pre-storage photos I took. Hopefully we will be reunited this summer.
For overlays, I would use epoxy instead of double stick tape. Fitment is way better.kit looks good but fitment is just ok. Not happy how it fits above the gauges. I think part of the issue is the tape used. Emailed Forgitec multiple times with no response.
More info?
