Sponsored

Camshaft sensor issues Help please!!

MyPro5.0

Well-Known Member
Joined
Jan 19, 2016
Threads
55
Messages
219
Reaction score
8
Location
San Diego CA
Vehicle(s)
2015 Guard Green Mustang GT Premium
Hello my friends recently I did OPG's and my CS at the same time as my V7-JT install since I needed to take half the parts off anyways to get the blower in and came across a very weird issue.

I cannot recall getting any codes on innitial start up but soon after I noticed I was getting codes P0365 and codes P0369, I would clear them with my Ngauge and they would disappear and not reappear the next time I turned the car on, but the following time after they would appear again. Anyhow, the car drove perfect and completely like it should have except for those damn codes. UNTIL I was on my way home from the gym and right before I stopped at the pump at the gas station my car began I missfire super bad, it literally sounded like I had a ghost cam tune. My throttle also became non responsive and I could not give my car any gas, at the same time I looked and my oil pressure became low. Now all of this happened at once for no reason after it had ran perfect for the last few days other then those codes that were on and off.

I got the car towed and now I have three codes P0345, P0390 and lastly P0365, only one of which had been previously mentioned. The car starts but stays at a very low idle and it's still firing odd, I am having a feeling it's the harness but I can't tell, Can anyone help please!!
Sponsored

 

markmurfie

Well-Known Member
Joined
Jun 6, 2015
Threads
15
Messages
1,320
Reaction score
625
Location
Hawaii
First Name
Mark
Vehicle(s)
2015 Ford Mustang GT
Cam shaft position sensor codes. One of them being intermittent. Sounds like a pinched wire, wire was rubbing on something, or was sitting on something hot and started to short to ground. Id suggest following the wires from the position sensors and seeing if any area is damaged and what caused it.
 
OP
OP
MyPro5.0

MyPro5.0

Well-Known Member
Joined
Jan 19, 2016
Threads
55
Messages
219
Reaction score
8
Location
San Diego CA
Vehicle(s)
2015 Guard Green Mustang GT Premium
Sadly no

Did this get figured out?
No sadly this led to my engine blowing in idle, so I'm rebuilding my engine then I need to get his figures out asap
 

Sponsored

5ohcoyote

Well-Known Member
Joined
Sep 5, 2019
Threads
10
Messages
72
Reaction score
27
Location
El Paso, TX
First Name
Nick
Vehicle(s)
2016 mustang GT
I’m having the same problems, the shop is saying PCM. It’s being replaced tomorrow so hopefully that will fix it.
 
OP
OP
MyPro5.0

MyPro5.0

Well-Known Member
Joined
Jan 19, 2016
Threads
55
Messages
219
Reaction score
8
Location
San Diego CA
Vehicle(s)
2015 Guard Green Mustang GT Premium
I’m having the same problems, the shop is saying PCM. It’s being replaced tomorrow so hopefully that will fix it.

Reset your Cam Position, this can be done via a tuner. I used my Lund Tuner and it fixed the problem
Sponsored

 
 








Top