Boost+ power wire?

[doodguy]

Hey all! Can anyone advise the best thing to do for Lund Ngauge Boost+ Power wire?

Should I use fuse tap? If so any tips on which fuse I should tap into? Should I just splice into another power wire somewhere? Help?

Sponsored

 

[whatsup62]

I used a fuse tap and went to a 5amp fuse in top right corner of fuse box inside car on pass side. It was a switchable source and has worked fine with no issues. Guess a lot depends where you mount the boost+ and the closest place to a power source. I mounted the boost+ inside car on drivers side so all I had to do was run a power wire through the dash over to pass side.

 

[doodguy]

I used a fuse tap and went to a 5amp fuse in top right corner of fuse box inside car on pass side. It was a switchable source and has worked fine with no issues. Guess a lot depends where you mount the boost+ and the closest place to a power source. I mounted the boost+ inside car on drivers side so all I had to do was run a power wire through the dash over to pass side.

Thanks!

I have the fuse tap all laid out under the main fuse panel under hood, just not sure where to plug it in; any open spot?

 

[whatsup62]

Thanks!

I have the fuse tap all laid out under the main fuse panel under hood, just not sure where to plug it in; any open spot?

Not sure about that fuse panel. If you have a test light or meter main thing is a switchable source. Don't want power on it all the time.

Sponsored