Any advice on how to remove the factory front bumper vents? I have the RTR vents and attempted to install them when I installed a new front splitter but gave up after fighting with those dang tabs for a while. The videos online always make these things seem a lot easier than they usually are.and added new air inlets to replace factory.
That was the toughest part. I don't have any good advice other than keep working at them. I was worried they'd break, bit they were fine. Just have to make sure the inlet clears all tabs.Any advice on how to remove the factory front bumper vents? I have the RTR vents and attempted to install them when I installed a new front splitter but gave up after fighting with those dang tabs for a while. The videos online always make these things seem a lot easier than they usually are.
The roof wasn't considered; I'm not a big fan of the black roof. I did think about doing the mirrors originally, but decided the handles were a bit more subtle. Also, I haven't seen a lot of mustangs with black handles. Maybe I'm not looking hard enough. LolThis might be too much black for you, idk - but I think a black roof and mirrors would look great in addition to all the nice work you have already done.
I have a black car and when it was wrapped I left the handles, mirrors, roof, wing, and hood vents black. If I wrap it again I’ll probably do the same thing. But you’re right, I don’t think there are many mustangs with black handles, at least in my area.The roof wasn't considered; I'm not a big fan of the black roof. I did think about doing the mirrors originally, but decided the handles were a bit more subtle. Also, I haven't seen a lot of mustangs with black handles. Maybe I'm not looking hard enough. Lol
Very nice! Could you send a closer shot of the hood vents? I'm curious how those look in black. Are they stock and wrapped?
https://www.americanmuscle.com/mmd-by-foose-mustang-bumper-vents-matte-black-406619-99.htmlLooks great. Who makes that inlet?
Never thought to do that, but I really like that. Reminds me of the lower front valence of the 2012 Boss 302 and California Special.I wrapped the area between the front lip and lower grille which is the second pic