Black wrapped spoiler and handles

[cpilch78]

Other exterior mods:
Tinted backup light and tail markers. Changed out chrome emblems to black, except the white GT (Plasti dip). Changed side markers to white. Tinted front signals and added new air inlets to replace factory.

Sponsored

 

[AgentAlex]

and added new air inlets to replace factory.

Any advice on how to remove the factory front bumper vents? I have the RTR vents and attempted to install them when I installed a new front splitter but gave up after fighting with those dang tabs for a while. The videos online always make these things seem a lot easier than they usually are.

 

[cpilch78]

Any advice on how to remove the factory front bumper vents? I have the RTR vents and attempted to install them when I installed a new front splitter but gave up after fighting with those dang tabs for a while. The videos online always make these things seem a lot easier than they usually are.

That was the toughest part. I don't have any good advice other than keep working at them. I was worried they'd break, bit they were fine. Just have to make sure the inlet clears all tabs.

 

[cpilch78]

I'm assuming you have the bumper off. I don't think it could be done if not.

 

[regachoz01]

That’s sweet! Are you planning to change your wheels someday?

 

[17gt_charlotte]

This might be too much black for you, idk - but I think a black roof and mirrors would look great in addition to all the nice work you have already done.

 

[cpilch78]

That’s sweet! Are you planning to change your wheels someday?

Thanks! No, I'm happy with these wheels.

 

[cpilch78]

This might be too much black for you, idk - but I think a black roof and mirrors would look great in addition to all the nice work you have already done.

The roof wasn't considered; I'm not a big fan of the black roof. I did think about doing the mirrors originally, but decided the handles were a bit more subtle. Also, I haven't seen a lot of mustangs with black handles. Maybe I'm not looking hard enough. Lol

 

[86pagt]

Looks great… I went the extra step with black hood vents and mirror caps… might consider doing the roof.

 

[17gt_charlotte]

The roof wasn't considered; I'm not a big fan of the black roof. I did think about doing the mirrors originally, but decided the handles were a bit more subtle. Also, I haven't seen a lot of mustangs with black handles. Maybe I'm not looking hard enough. Lol

I have a black car and when it was wrapped I left the handles, mirrors, roof, wing, and hood vents black. If I wrap it again I’ll probably do the same thing. But you’re right, I don’t think there are many mustangs with black handles, at least in my area.

 

[cpilch78]

Looks great… I went the extra step with black hood vents and mirror caps… might consider doing the roof.

Very nice! Could you send a closer shot of the hood vents? I'm curious how those look in black. Are they stock and wrapped?

 

[86pagt]

Very nice! Could you send a closer shot of the hood vents? I'm curious how those look in black. Are they stock and wrapped?

OEM vents, mirror caps and PP1 spoiler. I wrapped the area between the front lip and lower grille which is the second pic

 

[JK47]

Looks great. Who makes that inlet?

 

[cpilch78]

Looks great. Who makes that inlet?

https://www.americanmuscle.com/mmd-by-foose-mustang-bumper-vents-matte-black-406619-99.html

 

[AgentAlex]

I wrapped the area between the front lip and lower grille which is the second pic

Never thought to do that, but I really like that. Reminds me of the lower front valence of the 2012 Boss 302 and California Special.

Sponsored