2016 V6 Mustang [Turbo Project]

[StangATX]

Little update: Turbo remote oil system is assembled. I'm just looking into making a bracket to hold the turbo in place. I'll update another picture of the updated setup. this picture is when I assembled it but I changed the feed line pipe of the oil tank.

Sponsored

 

[diablomatt]

Little update: Turbo remote oil system is assembled. I'm just looking into making a bracket to hold the turbo in place. I'll update another picture of the updated setup. this picture is when I assembled it but I changed the feed line pipe of the oil tank.

is there going to be any provision to cool the oil since it appears to be a self contained i unit? or will it not get that hot with it being in the back?

 

[StangATX]

is there going to be any provision to cool the oil since it appears to be a self contained i unit? or will it not get that hot with it being in the back?

For now I won't use a cooler since I won't pass over 8PSI. Whenever I'll go over 8PSI then I'll add an intercooler. It's rear mounted it should have any problem to cool down

 

[diablomatt]

For now I won't use a cooler since I won't pass over 8PSI. Whenever I'll go over 8PSI then I'll add an intercooler. It's rear mounted it should have any problem to cool down

I meant an oil cooler to cool the oil supply for the turbo

 

[fordguys550]

Yeah..gunna need a oil cooler for sure

 

[zackmd1]

I doubt he will. I doubt that turbo housing will get much above 200-300 degrees mounted so far in the rear of the exhaust flow.

 

[StangATX]

I doubt he will. I doubt that turbo housing will get much above 200-300 degrees mounted so far in the rear of the exhaust flow.

Yes, you're actually right. I won't use one because it's rear mounted and the max temp it'll run would be 200 degrees. I was going to add one and figured out I didn't need it for now.

 

[fordguys550]

Looking forward to how this is going to work i know it has worked on plenty of other cars in the past

Sponsored