pouncer11
New Member
- Thread starter
- #1
Good evening,
I have searched high and low, and I am either too dumb to understand, or missing a few things. I apologize in advance if this is the equivalent to "what oil" threads.
I am looking to add a sub like everyone. The car has the 9 speaker stereo. My understanding is that the stereo dumps a low level input to a factory amp, and that some have built connectors to bypass this and essentially get RCA output for their stereo config.
I have seen that you can program changes, like disabling the stupid fake engine noises, disabling the house curve for the eq, and there was also talk of "Stereo Flat Line Out". Im not sure if I understand this one?
I am hoping to avoid using an LOC, and wanted to come here first to understand things.
Can I splice in RCAs off of the front speaker outputs between the amp and radio unit? Im not looking to do a full build, this is my wifes car, just wanting to provide bass.
I have power wire run through the dash, I have remote wire tapped in the trunk. I just want to get that low level input before I tear the seats out and run wires.
Thank you in advance.
Edit: I should add that I bought an OBD connector that should allow me to run FORSCAN and make changes if needed, mostly excited about deleting the fake engine noises.
I have searched high and low, and I am either too dumb to understand, or missing a few things. I apologize in advance if this is the equivalent to "what oil" threads.
I am looking to add a sub like everyone. The car has the 9 speaker stereo. My understanding is that the stereo dumps a low level input to a factory amp, and that some have built connectors to bypass this and essentially get RCA output for their stereo config.
I have seen that you can program changes, like disabling the stupid fake engine noises, disabling the house curve for the eq, and there was also talk of "Stereo Flat Line Out". Im not sure if I understand this one?
I am hoping to avoid using an LOC, and wanted to come here first to understand things.
Can I splice in RCAs off of the front speaker outputs between the amp and radio unit? Im not looking to do a full build, this is my wifes car, just wanting to provide bass.
I have power wire run through the dash, I have remote wire tapped in the trunk. I just want to get that low level input before I tear the seats out and run wires.
Thank you in advance.
Edit: I should add that I bought an OBD connector that should allow me to run FORSCAN and make changes if needed, mostly excited about deleting the fake engine noises.
Sponsored