Jay-rod427
Well-Known Member
Nobody has responded with a pic of the imrc. Can you just remove the butterflies and epoxy the holes shut? Cheapest non zip tie lockout there is.
Sponsored
When open, the runner is smooth.Gotcha. So ford finally made them not interfere the air path much when open?
As long as the actuators do not get any vacuum the IMRCs will stay open. So you don't have to remove anything or zip tie anything. That's how my car is setup and it's working great.Nobody has responded with a pic of the imrc. Can you just remove the butterflies and epoxy the holes shut? Cheapest non zip tie lockout there is.
So the ridiculously overpriced lockouts aren't even needed?As long as the actuators do not get any vacuum the IMRCs will stay open. So you don't have to remove anything or zip tie anything. That's how my car is setup and it's working great.
My buddy ran against a stock GT350R in the 1/2 mile and was pretty much dead even with him from what he told me and video he posted up on YouTube. His mods are listed below:Anyone do a run against an N/A GT (with similar mods) that doesn't have the manifold installed? I did two runs and was ahead by a fender. I was expecting to be ahead by at least half a car, but maybe a driver mod is needed for my car.
Both cars are manual with 3.73's.
No sir, that's how Shaun @ AED tuned my car and it's putting down great numbers with no issues. If you're not running IMRCs it's pretty much just a drop in and you don't have to remove anything or plug in anything in the back either.So the ridiculously overpriced lockouts aren't even needed?
I only did it because I was paranoid as hell and didn't trust the IMRC to somehow not close a little due to vibration/bumps.No sir, that's how Shaun @ AED tuned my car and it's putting down great numbers with no issues. If you're not running IMRCs it's pretty much just a drop in and you don't have to remove anything or plug in anything in the back either.
TBH I was a little paranoid about it too, but I thought to myself trust your tuner since he's a professional, you're not. So I went for it and everything was perfect lol.I only did it because I was paranoid as hell and didn't trust the IMRC to somehow not close a little due to vibration/bumps.
Jay-Rod, don't overthink it and throw on some zipties. I have two on each side and so far, so good.So the ridiculously overpriced lockouts aren't even needed?
Or this. WAY cheaper than $70.00.Or go to Home Depot, get some aluminum flat bar, cut it, drill holes, install it.