Sponsored

wheel hop

  1. Bad wheel hop all of the sudden

    Hey everyone, I have a 2017 mustang gt manual FBO Lund tune. I just got new clutch put in but this has nothing to do with my issue but after I’ve noticed I have extreme wheel hop on the 1st through 3rd on 1st gear pulls and launches. It never was this bad before. Alignment is good also and tires...
  2. Anyone else notice... (in regards to wheel hop)

    I see wheel hop pop up quite a bit and how had it is on the s550 and also how people don't have it. I was one of the "don't." If I spun my tires that was it. I didn't get any hopping. However, I recently had traction control on (I usually keep advanced traction control off because, assuming...
  3. Does more tire grip equate to less wheel hop?

    My Car: 2015 Mustang performance Pack, SCT canned tune, BMR cradle lockout, 275 continental contiprocontact (all seasons, on the car when bought used), everything else stock Problem: I take my car to the strip on occasion but my car wheel hops almost just as bad now as without the cradle...
  4. Todd15Fastback's '15GT PP Build

    Guess it is time to get my build thread going. My car was ordered on 5/21/2014 and was built on 11/24/2014. I ordered it through Jeff Greenly @Yocum Ford in Lansdale, PA. This was the best new car buying experience of my life, bar none. Jeff is the ultimate Mustang and Ford performance car nut...
  5. Steeda S550 Mustang Rear IRS Subframe Support Brace (2015 Coupe) - Now Available

    With the release of the new S550 Mustang, Steeda knew that addressing the IRS system would be a top priority. Being the first production Mustang with an IRS since the 03/04 Cobra’s, we knew there would be a great opportunity to capitalize on Ford’s new piece by giving it the Steeda advantage. As...
  6. Steeda S550 Mustang IRS Subframe Alignment Kit (2015) - Now Available

    Hi everyone, You asked and Steeda listened! We were lucky that our 5 in-house S550 Mustangs all came with the rear subframe aligned properly from the factory. But, what we noticed was a lot of people out there were not as lucky. The team here at Steeda went hard to work when we started...


Top