Search results

Are those two NA secondary air and heated cat? What does NA mean, we dont have the sensor in car?

So, I had repleced my battery and I need to get the inspecrion soon but I see few of the components are not ready. I have already driven 600 miles. So my questions is which sensors does mustang gt have, Not sure abour this at all. Anyone have an idea on this and which ones should be drive cycle...

OK, so finally this has been resolved. The back seats were the issue on these. I spray them with Lithium grease on all three points that the seats move or is attached and well the noise is gone. I was surprised that seats could make this much noise lol. All in all after lot of hours of checking...

How did you tighten that bolt I can't access with a slim socket and how much did you torque?

So spraying the trunk area did not do anything but I actually sprayed some grease on the rear back seat that did some trick, no squeak on the bumps but I still get squeak seem to be from other area when I go in and out of the drive way.

I have the exact same play on the half shaft and I have a squeak/cluck were you able to figure out the clunck.

I checked and looked fine. Here is the pic, idk why there is two holes up and down, is that by design. Also only the passenger side has holes and driver side doesnot.

Ok got it. Will give it a try.did you spray it from trunk or underneath?

Thanks for the info, so did you added the seam sealer from the trunk or underneath. Which one did you use?

Hey Everyone, I have tried almost all the possible remedies I can think of but I am still getting creek/noise on the rear passenger side when I get in and out of driveway as well as going over some bumps. This is bad during the cold days anything over 75 the noise subsides, very minor. Here is...

Looks nice. What rear tire are you running?

I see ya, I am so disappointed with this.

So, I have steeda version with progressive springs, I hear thumping noise on all four corners but only happens when I first drive, then it is fine. But my biggest problem is the ride quality when I hit a bump it just unsettles the car and gets some bounce as well. Does anyone have the same issue?

Is the maximum camber -3 when its all the way inward? Thanks!

So you are not rubbing or hard bumps on 1.2 camber? That is surprising, I am at 1.8 I rub on hard bumps. Thanks for the info btw.

Haha, ya no option for all season on 305/30, also wanted some side wall. Looks like shop is not being honest.

What is your camber setup to?

Yes, It should have been around 1.6, 1.5 before alignment, I told them if they could do like 1.8 or 2 to tuck the tire in, and also provided them with the document(found here) for where to adjust. That is what I am trying to figure out if they just said it maxed out. The alignment sheet says 1.8.

Hey everyone, So, I have RTR tech 7 wheels 20x10.5 +45 on rear and I am running BfGoodrich Comp2 AS 305/35/20. I am dropped on Steeda Progressive 1 inch drop. I got it aligned as well rear camber at 1.8. I am rubbing when I go through bumps. From what I have read the tire and the wheel and...

Ya, I was also thinking of H pipe but then as is sounds so good. Have gotten so many compliments. I don't have any drone, also I drive mostly on Sport mode. I have 3.15, it a bit sluggish on normal drive mode.