Hey guys, quick question here. attached is a smaller log I had taken after fixing an exhaust leak I had. car is a 2016 automatic, Paxton car with a 3.6" pulley w/intake and exhaust. stock tranny. I outlined the area where the shift is actually taking place, if you follow the spread sheet you can...
Awesome information guys, thank you. Is there a kit somewhere to relocate the IAT sensor? I'm running a Paxton kit so my MAF sensor is right before the TB, maybe 10-12" (the rubber hose literally connects the maf housing to the TB) I can probably just tap into the charge pipe post intercooler...
Hey guys, I used to run water meth on my older twin turbo Audi making around 600whp. so i know the benefits and and the drawbacks of using it. this is not another pro/con post. My question to you all is this, where do you tap in to inject the water/meth mixture?
A little information on my...
Okay got back from ups today, shipping on anywhere on the east coast is pretty consistent around $50+$25 for shipping materials (bubble wrap, boxes, etc.) so $75, states in the Midwest are around $65 plus the materials so $90
Thanks guys, been looking at a 4C, I was going to go with a 3200 rpm stall, because that seems to be the sweet launch spot with my Paxton kit and I didn’t want to ruin every day drivability, But I may go with a 3600/3700 stall if it doesn’t change much, and then hold the rpms lower with a MSD...
Hey everyone, ive had a lot of interest in it, especially in cost for shipping, unfortunately I'm away for Christmas at the moment but once i get back i will take to UPS to find out shipping costs, if you don't holding tight for about a week and post or PM me your zip code i will get back with...
Youres looks a little different than mine, maybe mine is upside down and thats affecting it? I thought it wasn’t connected either, but It is connected to the manifold, it’s the braided line circled in these photos. I thought maybe it could be the boost also, but I’m not sure.
A shop installed the manifold for me, here’s some pictures, it’s pretty cramped for sure. If you find something wrong I’ll be forever in your debt lmao
Hey guys, looking at adding a higher stall converter to my 2016 Paxton car with a 6R80 when I pull the transmission build it a little. I’m looking into getting something around the 3600/3800 stall RPM, I’ve only seen good things about circle D converters, but have seen a few other brand names...
I’ve tried your suggestion, I’ve tried the video, I’ve checked the evap line under the car, and even heat wrapped them, thinking the exhaust is heating it up and causing this. Can’t figure it out for the life of me. Funny how it only happens after i install my Paxton kit and 18 manifold. Did it...
Hey guys, I’ve got a mishimoto oil cooler for sale, Oil runs just a little cooler, but roughly the same temperature, but would not be affected by coolant temps or anything, also stops coolant from coming close to being in contact with your oil. comes with a new lower radiator hose, and oil...
Hey everyone I’ve got a 3.5” one piece shaftmasters driveshaft, was only on my car for roughly 3k miles, no vibrations.
Asking $400, would rather not ship unless buyer is willing to pay shipping fees. Pick up would be in the raleigh Durham area of NC, or within 45 minutes.