I am removing the EVAP system from my 2018 GT/PP2 race car and was wondering if anyone has tips for properly venting the tank. I have the Holley roll over check valve/breather to install at the end of the vent just wondering what everyone did and what size hose was used to properly vent the...
For sale 2018-21 Mustang GT CAI, also has silicone adapter and clamps to use on 2015-20 GT350 and 2019-20 Bullitt with 87mm TB. Tube is wrapped in DEI Gold reflective heat foil. Price is $250 +$20 shipping. Pick up is free, zip is 10573 and I will meet in a 50 mile radius.
Looking for a reputable tuner who can write a good road race tune for the Bullitt Intake and TB(Digital 87mm) on my '18 Engine. Has JLT CAI, ARH LTH and 3" cat less Corsa Exhaust. No other internal mods except PAC RPM valve springs. None of the tuners I've worked with want to write it since they...
Have for sale a 350R rear seat delete. Great condition, has all the hardware, seat belt delete panels and foam blocks. Has two inch slits at each corner to fit around roll bar down tubes. Can be glued together and would be nearly invisible.
Asking $500 delivered within 125 miles of zip code...
This Item Is SOLD to mustangflanagan. Thanks to all that inquired.I have for sale my takeoff GT350 Intake manifold, includes GT350 87mm throttle body, GT350 specific brake vacuum line/hose and JDM wiring harness to extend to evap solenoid.
Price is $1000 shipped.
Thanks
Steve
Any of the tuners out there have experience tuning a Gen 2 Coyote using the Gen 1 ECU? I have an opportunity to put a '16 motor in my '11 racecar and know that the cam phasers changed. Don't want to have to change the cams and drives if I don't have to. Going to use CJ manifold currently on the...
Hope we can start a sticky. For those who want to share where they may be competing, Auto Xing or just HPDEing in the future this could get some folks connected at the track.
Date(s): Saturday/Sunday October 29 & 30
Track: Summit Point Main
Club or Organization: EMRA
Description: Sprint...
Can any of you 350R owners post the measurement from the rear edge of the trunk lid to the rear of the wing stanchions? Just got my Carbon 2 Carbon wing and would like to follow Fords OEM mounting position.
Thanks
Steve
Guys
I am working with KNS brakes to produce sets of titanium brake pad shields for our 6 piston 2015-16 Brembos. I have run these on my '13-'14 6 pot brembos for the last 3 years and have the original piston dust boots that look almost new. If anyone has a set of worn out front pads that we...