Sponsored

Search results

  1. Can anyone diagnose this sound?

    Squeaky sound from the rear when switching to and from reverse / drive. 10r80 3.15 gear ratio. Hoping its just my springs compressing under load but not too sure.
  2. Extreme Online Store Mach 1 Bumper & Ford Performance OEM Lower Splitter Compatibility

    Hello, does anyone know if the Extreme Online Store (EOS) Mach 1 bumper conversion for the 18-23 GT allows for a OEM Ford Performance Mach 1 lower splitter transfer? Heard under higher speed and slight rubbing can cause the lower splitter from EOS to crack/break so I’ve seen people swap to the...
  3. Drag pack lug nut socket

    Hey, anyone have a good recommendation on a deep enough and thin enough 19mm socket to tighten lug nuts on weld dragpack? I had to shave down the sides of a normal 19mm to avoid hitting the side of the wheel. Please let me know! Thank you!
  4. VMS Lug Nuts 14x1.5mm

    Hey, does anyone know if these lug nuts are gonna be safe and secure on my beadlocks? Got 17x10 belmont weld beadlocks and bought these lug nuts to keep them secure. Just wanna make sure I chose the correct route as a sanity check lol.
  5. Weld Beadlock Lug Nuts

    Impulse bought belmont beadlocks on the way home from a trip to florida.. what lug nuts should I use to put them on? Didn’t think that through lol.
  6. Euro Reverse Light 18-23

    Anyone know where I can get a euro third brake light for a 18-23 GT? I’d prefer to be plug play and no cut/splicing but I can if I need to. I’ve seen it on a few cars.
  7. What TPMS do I buy?

    Got new wheels! What TPMS should I get?
  8. O2 sensor placement on headers (caught on fire)

    Hey everyone, after installing catless long tube headers, I’ve been having a ton of issues with my o2 sensors.. driver side fell off, and was ripped in half. Passenger side just caught on fire, and almost took my car with it. People suggested heat wrap or a o2 spacer to pus further away from my...
  9. Catless fumes in cabin

    Hey everyone, just put in Catless long tube headers and the cabin reeks. Especially during cold starts, and when at a stand still. Any advice? Was looking at high-flow cats but a buddy said it doesn’t change much. Thanks!
  10. 10r80 Gear Shifter Won’t Go/Stay In “S” Sport Position

    Hey everyone, the other night while doing a LTH install, I needed to move the car but couldn’t turn it on so I pulled up the 10r80 gear shifting column to move it into neutral and after everything was done when I drove the car it felt mushy clicking to the “S” position and clicked itself back...





Top