Sponsored

Search results

  1. Pedders camber plates increase noise, help…

    Greetings all, I recently installed a set of Pedders camber plates to go with my Pedders coilovers that have been on the car for several years. Prior to the camber plate install, my front and rear suspension was pretty darn quiet after chasing a few noises over the years. Now that the camber...
  2. Need fitment help! 2016 s550

    Greetings! I have run into a snag and am hoping for some advice…. I have a 2016 GT currently running squared 20x10 SVE wheels and a 275/40/20 tire. I also have the factory Perf. Pack staggered set with all season tires. I have run the 20ā€ wheels for autocross with Firestone Indy tires. They...
  3. How to stop the rear end clicking?

    ā€˜16 GT. The rear end, mostly the driver side, clicks when accelerating from a stop, or similar. I have replaced both driver and passenger rear bearings and switched out axle nuts. Torqued to spec and beyond. Any thoughts? I am super sick of the noise!!
  4. Help…Valve cover replacement, broke dipstick…

    So I am in the middle of the GT500 valve cover swap on my leaky 16 GT. I managed to mess up the original dipstick tube and it is not useable. Good news, I ordered a replacement just in case. However, the replacement I ordered does not have the yellow extension from the valve cover, it sits...
  5. Help…front sway bar hitting lower control arm…

    I’m sure the answer is buried in another thread but I was hoping for a quicker response. 16’ GT PP, lowered on Pedders Coilovers. I had the dreaded low speed clunking and replaced my sway bar end links with OEM style and now the clunking is worse. Figured perhaps I did t get the right torque.
  6. Advice on damaged K-member…

    So yesterday while driving in traffic, I ran over a rock the size of a softball. Another vehicle kicked it over before I could even react. I pulled over and locked under the car immediately, no obvious leaks, thankfully. I climbed under the car today and discovered the damage. The...
  7. Clunk in front end when braking?

    16 GT PP….Recently I’ve noticed that if I stab the brakes when rolling a bit, or slowing down for a light, the front passenger side suspension seems to have a bit of a ā€œclunkā€ when the big ol’ brembos grab. It seems like something is loose, or maybe the wheel bearing is bad? I haven’t ever...
  8. Mystery rattle, please help!

    2016 GT PP….I have an annoying rattle at the rear passenger side wheel area. It sounds like metal to metal, like a loose nut, but I cannot find it. It seems to be right at the wheel well and I hear it from inside. Mostly during slow driving and bumpy roads. It’s driving me insane! The car...
  9. Under hood power for lights, help

    I know there are a million threads about lighting and power on here, but I am struggling to find an answer to my specific question…. I am just adding a couple of small led lights (bullet like) to the grill and would like them to come on when the car is on. Can I tap a specific fuse, or do I...
  10. Help with serp. belt chirp/squeal

    Need help with recent chirp/squeal from serpentine belt on my ā€˜16 GT. I have searched some of the other posts, but I’m still a bit lost on what to do. When A/C is on and I’m driving around, I get the occasional belt chirp/squeal and it seems to be getting worse and more frequent. I popped...
  11. Spacer help with ‘16 GT!!

    I needed new rear tires and picked up a pair of 275/35/19 for my PP wheels. I am running 1ā€ spacers as well, but it appears that the tire may have scrubbed the fender. I removed the spacer, but now the wheels sit too far in. Can I get a 1/2ā€ or 3/4ā€ spacer and help the issue? What all should...
  12. Troubleshooting help…’16 base

    I have a new to me ā€˜16 GT base. Obviously the stock stereo blows. I installed an LC2i pro LOC and a four channel amp. Currently I have the main channel RCA’s on the LC2i running to channel 1 and 2 on the amp. These channels from the amp are run to Infinity door components. The other two...
  13. Any Portland area people with Forscan for EQ?

    Howdy! Just picked up a ā€˜16 Gt with a base audio system. I was wondering if anyone has the Forscan program locally that would help me to remove the factory EQ programming issue with the base system? I’m not super tech savvy…. Thx





Top