Search results

So the manual outlines at 30,000 mile service. My dealer is quoting $345 for this. It includes: oil change Engine air filter replacement Cabin air filter replacement Hose check Steering / tie rod check Suspension inspection Coolant and fluid check Alignment check

Where are you located ?

The only bad part is that the wheels were at full tilt in both directions to angle of being pulled out

Front

I was thinking steering more than suspension

No roughness or clicking. The only thing, and I’m not sure if it’s always done this, but the steering feels kind of “bouncy” at low speeds ? Like if I jiggle it a little to the left it’ll jiggle back to the right and vice versa.

Any symptoms to look out for?

The dealer checked the alignment and said it was still good

Hey! So I had my car winched out of the mud over the summer after swerving to avoid something in the road. Basically they tied a rope to the wheel spoke and winched the car out. I involved me holding the wheel at full turn on each side. Because of how much force I had to put on the wheel, I’m...

The car came with 235 50 R 18s and the takeoffs are: front - 305/ 30R 20 Rear - 315 / 30R 20 I know the speedo will be off, but are these too wide or tall to fit?

Long story short over the summer I had to veer off the road and into the mud. The car had to be winched out by its wheels (they tied a rope around each wheel and pulled me up. I’ve noticed that the wheel doesn’t seem 100% straight. The dealer checked the alignment and found no issues. My tires...

Using?

Do you chock wheels at all?

Can the actual Jack with adapter go anywhere on the pinch weld so I have room to put the stand on the plastic cutout ?

Am I good to put Jack stands on the pinch welds in the little cutouts in the plastic side skirt? going to be changing wheels tomorrow. I have a floor Jack and a pinch weld adapter. I was going to jack up via the pinch weld and then put the jack stand on the pinch weld where the little cutout in...

Going to be making the trip from Cleveland to Chicago this weekend. I currently have the PP P Zeros with about 5/32 of tread left on the car. I usually just swap out these for the skinny P Zero Nero’s that came with the car for winter since I have a separate 4WD that I use. Because of this, the...

Had to serve into the grassy median after a large piece of metal flew off a semi.

I did get some scuffs. I was worried because they had me turn the wheel fully to each side when pulling me out. It took a lot of strength to keep it turned, so I was worried it bent something. Im getting my oil changed next week at my normal dealer and they said they’d check the alignment for me.

No vibrations or anything. The dealer didn’t seem to find anything. I still feel like it drifts to the left, but I’m not sure if I’m just being a hypochondriac. this pull out happened like 4 months ago, so I’d assume I’d see tire wear if the alignment was bad. Might have it looked at by my...

So I got my car stuck in some mud and had to be winched out. They tied a rope through the wheels and winched me out that way. Do you think that could have caused any damage? I’ve noticed sometimes it will jolt itself over a little bit, but I’m not sure if that’s attributed to tram-lining due...