Search results

Scary close. I lived in Freeport but those pics were in Huntington. Do I know you ?

Great idea! I too have that issue on the right side. I'll try that method myself.

Long time ago Huh? Here was 1990. Circa 1990 No comments on the hair please.

Probably so, but I've always with most everything mechanical want to improve them in one way or another. That is until I get in over my head and then get so pissed at myself. Fortunately that doesn't happen all that often. I know my limits and respect my fading patience.

This feels like a flashback in a sense. Way back in the day I owned a 77' Chevrolet Monza, factory 305 car. The OE 305 was tired so I swapped in a 350 out of a Chevelle I had bought just for the engine. In my infinite (young/stupid/mostly clueless) wisdom, I swapped out the heads for a set of...

The Boy turned 6 today. He gets doggie ice cream (bacon & cheese flavor) and loves it.

The float must have stuck. I filled the car up again today, and now its working again correctly. Weird.

I sure wish you had an installation center in Pompano, I'd be there in a heartbeat for exhaust and suspension work.

Hi Folks, Started my day like yesterday with getting some gas for the 2020 EB work car. Filled it up, and it wasn't but maybe just below half a tank. I get back into the car and start it up, and the needle is right back where it was when I pulled up to the pump?! I track my MPG in this car...

Need I say more? I saw this last week while in traffic. Women love these tires, so I am told.

Fun day today in 95f heat but at least I was in the garage. Rear wheel bearings & front brakes on the 2020 eb work car.

Hi again, No, as it was explained to me here on the forum, only a "Tune" can access the idle speed. Forscan can access the BCM but not the engine Tune it self.

I have never seen one in that shade of Red down here. Interesting for sure. Enjoy and good luck !

Yes it is. I even had the car back at the dealer when it was still under warranty. The said no codes, can't do anything about it. A simple bump in idle speed by 100-150rpm's would solve it. When it happens, the exhaust vibrates which makes a bunch of noise. I sometimes drop it into neutral at a...

Fortunately, I do not have 1st hand experience with the new law & also have a clean record.

Hi there. It sounds like you are describing the typical ecoboost idle shake when the a/c cycles on. Mine does it, some days worse than others.

Yeah, that's the logic I was working with initially as well. I've yet to do a disconnect of the battery, but I'll try that at least today just for the Hmmm factor. If that does nothing, I'll call my service tech (for company car/other Mustang) and get his opinion.

I too have a similar if not the same thing happening with my 21'. On start up, the air blows from the footwells and the defrost a bit but no dash vents. If I go into the climate screen and turn off the floor vents, then I get flow through the dash vents. I typically keep the floor and dash vents...

Not to make this thread any more opionated or muddy bit there is 1 fact I'd like to offer. HID lamps, no matter what color temperature belt out a bunch of UV light. I ran 50w/6k set up's in my 2015 GMC Canyon. I used this set up for 3-4 years before I transitioned to LED's. The HID's actually...

A GT/CS with the PP1 package has got to be a rare combo. Enjoy the new ride !