Search results

Yeah ok, do you have a photo?

If you install the hose the opposite way of the instructions, it will fit without kinking or heating. Put the 90dg fitting at the separator, and the 45dg fitting at the intake :thumbsup:

I have seen 18" Signature wheels on the rear of both 350's and 500's. Not sure about Forgeline, but an 18" can be done.

Yeah that's actually pretty disgraceful that they failed like that. I was about to pull the trigger on a set, but deep inside I knew something wasn't right with how cheap they were (the cats that is). The limiting factor will always be the wallet mate ha ha. I'm up on the sunny coast but will...

Hey awesome thread. I'm just new to QLD and it's great seeing someone going all out on their late model mustang. Hey, were the cats that grenaded the 100cell x-force ones that come as part of the kit?

Yeah you definitely don't need twin 3.5" exhausts on a Whipple to make power. You'll make a lot of power on twin 2.5" exhausts. And whipples don't run a front mount intercooler, it's part of the SC system.

As with most things these days. Thanks for the feedback.

Yeah nice. I might do the same thing. Let me know how it goes.

Is that the B-line x-pipe?

Oh I bet. I just started doing vlogging and I can't believe the amount of time it consumes. I bet you could have installed everything in half the time or less if you weren't worried about the camera :like:

Great video, very thorough. I already commented on your YouTube video, but as I said it's great that they added the separate horizontal on the rear kickers. Awesome job.

Hey all, After driver and passenger side mirrors. Must have turn signals and puddle lamp provisions. Not fussed on color. Must be willing to ship to Florida. Thanks

18+ vibration dampeners are fixed, not bolted on. I wonder if this was because they were working themselves loose on the early models.

He measured right. However nominal rim width (the advertised width) is measured between the bead seats. Bead seats are usually around 1/2" each side. So an 10.5" wheel will actually measure 11.5" if you are measuring the overall width. So based on his correct measurement, he would have 9.5" and...

Turn the power on without your foot on the clutch and let the valves cycle first. Alternatively if you clutch it in before pressing anything it will cycle the valves. Then hit the start.

fair enough.

Go on to Facebook and search this, then watch video. "Desk Drives: Mustang Mach 1 with Rick Kelly"

Mclaren 765lt didn't take much to get it in the 8's.

I still don't buy it. If it had enough crankcase pressure to blow out the drain plug, the dipstick would have blown out well before that. Incorrect figment of the drain plug or repeated use of the same drain plug may have worn it down. I dont know what the exact issue was, but saying that...

The GT500 runs a metal pan and plug. However, that YouTube video and event you are talking about is not normal. If any car, plastic drain plug or not, blows their plug out during a pull, it means that: 1. It's wasn't on properly or functioning correctly and/or 2. That engine has some serious...