Search results

Installed my Beith Performance carbon steering wheel and aluminum dead pedal. Excuse the shitty cell phone pic.

Shitty cell phone pic.

I just received my custom steering wheel from Beith Performance and I have to give Tim recognition. Tim provided excellent service in keeping me informed on the status of the wheel over the 4 weeks and promptly answered every email that I sent him in an expedited manner. The wheel arrived as...

I know it doesn't help with your problem but this car is the biggest rock magnet I have ever seen. Take the belly pan off a ton of rocks fall out. Remove the rear springs and the lower control arm is full of rocks. Reach under the backside of the rear bumper... full of rocks. Any place a rock...

Trevor is the right person to respond to your question as his tank is in the spare tire well. Mine was too big and also purchased by Hyper. The mix-up was with Specialty Suspension on the size but it worked out better for me. So I didn't send it back. My install is not in the spare tire well...

You have to be careful when ordering a specialty suspension tank due to how they are machined since it is one piece of aluminum and how they are labeled. A 5-gallon is actually 3.5-gallons internally. When I ordered my tank through a vendor. I wanted the one that fits in the spare tire well...

You have to remember there are thousands of car guys just like you trying to get a sponsorship. You have to be the one that proves to them why you are better than the next guy. Otherwise, you are just another looking for free/discounted parts. If you can answer yes to the majority of the...

The Dulles C&C on Sunday is where you want to go. It will have the biggest group of Mustangs as well as lot's of other cars as well.

They will auction your car off to recoup some of their loss. Salvage places buy them all the time and part them out and resell the good parts back to bodyshops... etc.

Just placed an order for the following: Reverse lockout collar Red Anodized hood latch Vertical links Subframe alignment and support kit Toe link with knuckle bearing assembly

Car is beautiful!! Congratulations Allan. :hail::hail:

No write up but if you questions, feel free to ask.

I am running 1/4 and dual compressors. The 1/4 is easier to run than the 3/8 and the fractional difference in air up and down between the two was not worth it to me. My install is unique/custom and probably the only one out there where zero and I mean zero holes were drilled anywhere in the car...

Get yourself a set of train horns. They will know you are there :D

I've done two on jack stands in my garage. It is not hard just time consuming. The worst part is hammering out the strut bolts in the front. The bigger the hammer the easier they are. One other bit of advice. Unbolt/un-hang the rear exhaust hangers. It will allow you to lower the rear to a...

Look at the backside of the grille. You will see a line around each part where the honeycomb is. Used a dremel with a cut-off wheel and follow the line.

Tim - Money is on the way. This is going to be a long month waiting but will be so worth it when it gets here.

Just sent you a PM. I want a carbon wheel with leather, red stripe and stitching. Hopefully, I can get in this batch.

I will have the bumper you need in MG in a few days. Problem is, I am in VA and shipping would be difficult and cost a lot.

Congrats!!! I bet you have a perma-smile going on now. The car is beautiful. Are those clear tails or just the reflection from the sun? Looking forward to many pictures of this beast.