Search results

Getting an allignment right now. Going for BMR recommended allignment specs as much as possible with the components I have. I'll post pics of allignment specs afterwards. For those wanting to know specs: 2015 Mustang GT Performance Pack 1 13k miles 19x11+50 with Nitto NT05 305/35/19s all...

Just got them in. 19x11 with Nitto NT05 305/35/19 all around. Probably wont get then on until Sunday though. About to ceramic coat them with some cquartz 3.0 to make cleaning easier in the future.

I called LMR and asked if they would sell a square package with 19x11s but they would not. I bought all the components seperately and used the code "LMR6" for 6% off, which equates to $88 off. I believe what's recommended to run this set up is a 25mm spacer on the front with at least -2 degrees...

I picked up a square set of 19x11 in bronze with 305/35/19 NT05 coming in tomorrow. I'll post pics asap.

How was the OEM panel adapted to use the 8inch screen?

Just found out the GT350 radio panel womt work with a SYNC3 swap because of the circuit board. I'm thinking of using the base circuit board with a mix of buttons and knobs from both the gt350 and base panel. Has anyone done this before? I'm thinking this should be doable...?

I just picked up the following components from another member: 2016 GT350 Premium Radio Bezel 2016 GT350 Sync3 Module I will be upgrading a Base 2015 Mustang GT w/ cloth recaro seats (no heated seats). If I order the harness from Hextall, will that be the only other component I need aside from...

I didnt even see this all g with your other post. Is this Sync 3?

I'll take it. Sending you a PM right now

CB005 and Steeda IRS Subframe allignment kit. Ran into some trouble with stripping the threads on both sides of the frame, but thanks to this forum I found the M14x2 tap needed to fix the issue and got the project done.

My friends dad made brackets using the diagrams supplied by @Strokerswild. 304 stainless steel cut with a waterjet. Just got the brackets and engine cover on today. FYI, if you dont remove the cmcv vacuum connection on the rear of the manifold, then you'll have to cut the rear portion of the...

Ok. Let me know if you happen to change your mind in the future.

Willing to sell just the end links? I'm local near LBC

RTR style diffuser from ebay installed. For knockoff ebay item, the fit and finish is surprisingly really good. No issues whatsoever with install.

^ I feel the same about black wheels. Black hides the details of the wheels. I dig the bronze option as I've always been partial to that color on JDM wheels like TE37s or CR Kais. But, theres something off about the bronze they used...maybe a little too light of a shade.

PM sent btw. Cash ready.

Looking to buy camber plates that are usable with OEM PP Shocks. Preferred pick up in SoCal but open to offers.

Sending PM your way shortly

Where are you located? I'm in LBC and interested in a local pick up

What springs are you on? I'm trying to decide between 305/30/19 vs 305/35/19 on the 19x11s all around. I was going to pick up some Work T7Rs or CR Kiwamis in 19x10.5+32 all around, but I'm really digging these and the sizing is much more optimal for a square set-up.