Sponsored

Search results

  1. P068a code

    Okay. It does seem like it’s probably as simple as the battery. Car was perfectly fine before I left on vacation for 5 days… Hoping to get my car back tomorrow.

  2. P068a code

    My dad and I pulled all the fuses and relays appropriate to the problem and tested them all with a multimeter and they seem fine. I was questioning the alternator but wasn’t sure if that was the problem or not. And this may sound bad but I didn’t know you had to reset the BMS system after a...

  3. P068a code

    Sorry I was dropping it off at the shop whilst making the post I thought I included the battery being new my bad. And the inside voltage meter on the gauge cluster was reading 12.8 when I drove it to the shop, the entire 15 minute drive there, never went up more than that. It probably just...

  4. P068a code

    I just got a new battery last week. You think that would be it?

  5. P068a code

    Hello everyone. I have a 2017 mustang GT, I just got back from vacation and my battery for my car was dead after a week (left my dash cam plugged in assuming anyways) And it drove fine on the way home. Woke up today to leave and I get this code and the power steering is gone, has a check...

  6. P0308 Misfire Code, Erased and hasn’t come back?

    Fortunately no code for p0300. Just p0308. Still hasn’t come back either. Been driving to and from everywhere and nothing yet. I am worried about the IMRC being broken though

  7. P0308 Misfire Code, Erased and hasn’t come back?

    Okay. I’m just overthinking it. I thought it was weird it got deleted from the permanent code section on my scanner after a few drives

  8. Unstable rear end over bumps after suspension upgrade

    I’ve always had .12 or .14 toe in on the rear and have never had any unusual tire wear. I don’t think that’s an issue.

  9. P0308 Misfire Code, Erased and hasn’t come back?

    Yeeeet

  10. P0308 Misfire Code, Erased and hasn’t come back?

    Hello everyone. I have a 2017 GT PP, and yesterday on my drive home from work I got a check engine light on my car. I immediately ran to my parents house to get a code on it, and it read p0308 Cylinder 8 Misfire. I couldn’t feel a certain thing and it felt like it was driving normal, so I...

  11. Overthinking my mt82 manual trans fluid change

    I also do not notice any difference in shifts with the BG synchro 2 like everyone says lol.

  12. Overthinking my mt82 manual trans fluid change

    Thank you all. I did it last night. Had some trouble getting the stupid fill plug out since the clearance there isn’t a lot. I had to use an Allen key and a box end wrench to get enough leverage to move the dang thing but we are good to go.

  13. Overthinking my mt82 manual trans fluid change

    The only thing I need is an 8mm Allen right for the drain and fill plugs?

  14. Overthinking my mt82 manual trans fluid change

    Anyone ease my mind a little? I’m not sure why I’m overthinking this shit, but I’m worried I’ll mess something up somehow. Car on all 4 jack stands, 8 mm Allen socket, ratchet, 3 quarts of BG synchro shift 2 fluid with pump. Car is at 66k and I’m ready to do this. It’s so hot outside so...

  15. New Diff Bushings, Driveline Noise Normal?

    @KellTrac

  16. New Diff Bushings, Driveline Noise Normal?

    Hey everyone. I just had these KellTrac diff bushings installed on my 2017 mustang GT. I’ve been getting lots of noises coming from the transmission/clutch area since install. Is this just nature of the bushings probably being much stiffer than OE bushings from Ford? I heard a little bit of...

  17. Normal to hear shifting noises/clutch/gear after diff bushing install?

    Hey everyone. I just had Kelltrac’s differential bushing set installed on my mustang GT. I noticed since installing them and taking my car home today, it has noticeably more noise coming from the clutch/transmission area whilst shifting. Is this normal?? Should I be concerned? It drives like...

  18. Rear End Clunk over Lane Dividers at low speeds?

    I had my diff bushing and toe link to knuckle bushing replaced and the clunks are gone.

  19. Update for those curious, clunking at low speeds over bumps only fixed!

    Just got my mustang fixed. Rear differential bushings and the toe link to rear knuckle bushings replaced. All the clunking and pulling over the road is now eliminated. Drives so nice. I replaced my diff bushings with Kelltrac diff bushings and it feels incredible!

  20. What causes this uneven brake pad wear after 2 months?

    Awesome! Thank you so much. Yeah it doesn’t have any symptoms, I just noticed it when I was walking to my car after work yesterday I figured it was weird. Thank you for your help. :)





Top