Sponsored

Search results

  1. GT350 Gauge swap into 18 GT

    Okay after quite a lot of fiddling in Forscan, I got almost everything but my gas gauge is weird. Everything else is working, got rid of the blind spot monitoring, and all my gauges back. If you don't have track apps you probably have a Mykey issue. Also when you turn traction control off or on...
  2. GT350 Gauge Cluster Thread

    Okay after quite a lot of fiddling in Forscan, I got almost everything but my gas gauge is weird. If I put in 6 gallons on an empty tank (I ran out of gas once to prove this) the fuel gauge will go to full and the DTE won't be accurate until I'm within 30 miles or less of running out of gas...
  3. Misfire at high rpm

    Update, after ordering a new Crank position sensor and ensuring that it is in correctly (when putting it back in you can put it in crooked even if the bolt is tight) I successfully got it to relearn and the car is fine.
  4. GT350 Gauge swap into 18 GT

    2018 base GT 6spd manual 3.55 dif TSP 1' 7/8 long tubes catless N2MB WOT BOX Ben Calimer stage 1 Mt-82 Centerfource SST Pmas intake Oil separator clutch line PBD e85/93 tuned Problem: I need a hand, found a new 0 miles 350 cluster out of a 2019 and put in my 18 base gt manual, the dash is...
  5. GT350 Gauge Cluster Thread

    I need a hand, found a new 0 miles 350 cluster out of a 2019 and put in my 18 base gt manual, the dash is saying the blind spot monitoring system fault and light which my car doesn't have, and the track apps are not there at ALL? Also the gauge display mode ONLY shows miles till empty no temps...
  6. Misfire at high rpm

    Yeah Right now I have the stock intake back on it and stock tune, it takes like 3-5 seconds of cranking for it to start and then instantly goes into limp, tried resetting KAM memory, and the battery disconnected same issue. With the car in limp mode, there is no way for me to do a crank relearn...
  7. Misfire at high rpm

    Ok update, I went ahead and pulled the crank position sensor and sure enough there is metal shrapnel from my old clutch on it, and given that the sensor is magnetic and sensitive I assume that would most likely be throwing it off. However, since I did a crank relearn while it was messed up after...
  8. Misfire at high rpm

    I have had the WOT box in my car for over a year, yes the wires are all properly insulated and grounded, I checked every connection. Also to disable the features to make sure the box isn’t causing a fault all you have to do is press the button on the box once and the light turns off making it a...
  9. Misfire at high rpm

    2018 base GT 6spd manual TSP 1' 7/8 long tubes catless N2MB WOT BOX Ben Calimer stage 1 Mt-82 Centerfource SST Pmas intake Oil separator clutch line PBD e85/93 tuned Problem: Hi, I am slowly going insane trying to figure out why this is happening please help. Experiencing a miss or timing...





Top