Looking for a solution to attach rear license plate besides using the self tapping screws into the rear bumper, anybody use "nutserts"? Or should I just say "F" it and use the self tappers.
Sorry, my question wasn't very clear. Your response answered it though. I am using a spoiler delete trunk lid so I am guessing the stud will be tricky to line up for drilling. Appreciate the help.
I had a shop in town mill the bottom of the STB and powder coat it. Weakened it though, thinking about having a support welding to help strengthen it. Not sure if the STB is more for looks or if it actually helps "stiffen" up the front. I have read conflicting ideas on it.
Just finished Whipple Gen4 install with 10 rib setup, Fore Triple pump, TSS OPG and timing sprocket, SW long tubes w/cats, FatHouseFab oil catch can and lithium battery setup and PBD Tune.
Installed TSS OPG and timing sprocket, Whipple and Fore fuel system and PBD tune. Upon initial start up had CEL with camshaft position codes . Cleared codes and no lights on for the day of getting engine up to temp and test drives. Car sat for 2 days and on start up codes were there again...
Installed TSS OPG and timing sprocket, Whipple and Fore fuel system and PBD tune. Upon initial start up had CEL with camshaft position codes . Cleared codes and no lights on for the day of getting engine up to temp and test drives. Car sat for 2 days and on start up codes were there again...