BlownGP's latest activity

Yes, I eventually put pressure on the arm with a floor then started hitting the stud. lol. Was not fun. Thanks for the help though.

Ya, I had a fun time getting the ball joints loose. Tried every trick in the book. Just took a Barry Bonds' esque swing at it with a...

Well, you might find this funny. But I've only installed the drivers side one. I had HELL getting the ball joints lose. So with how long...

I installed some new front lower control arms with the Cortex solid bearings Well my driver side one is turned sideways. Is this normal...

GT500 injectors will fit Gen2 15-17? Why does CJ pony say they wont...

This is good and bad but I understand why they had to. VMP is still a small player in the game only dealing with Mustangs can only take...

Yes if you add ceratec on top of it.

haha. So there is no point. My tick is not that bad and if the internet wasn't around I wouldn't even know it was there. hahaah

So. Will this work on a 15-17?

Ok, thanks for the info.

Yes, I Dremeled clearance for the grommets as well as the boss for the IMRC. The bars just mount to the studs present on the top of the...

Well, it looks like it’s time to bring this thread back from the dead, at least briefly… In the summer of ’20 I sold off my ’18 intake...

Wow, I'm so happy I found this thread. I've been wanting to do the manifold swap for a very long time but I love my painted engine...

I've actually had conversations with another vendor about how to most effectively provide installation instructions for complex...

I use mine with jacking rails, they come with flat rubber lifting blocks and ones to use with pinch welds. I just use the flat blocks.