Lower air dam missing some screws from the factory.

[19gtaz]

Some of the screws look like they were never put in on my front lower splitter or air dam. You can see there is a nut there through the hole. The others look like 7mm hex head screw.
Has anyone else noticed this? Sorry no pictures.

Sponsored

 

[Ctodd1]

While you're at it, check the plastic screws that hold the rear wheel felt liners in place. Most of mine were ready to fall out.

 

[TEAsGrabber]

Yes.....Mine was missing a couple as well. The lower splitter is installed at the dealer and I think there's 4 or 5 bolts on each side that are R&R's along with all the plastic rivets. I inspected mine before leaving the dealership and had them run it into the service bay and install it with ALL the correct hardware. Half assed dealership techs at their fines, but hey....I used to be that guy when I was working @ my dad's dealership as a kid. LOL

 

[19gtaz]

Yes.....Mine was missing a couple as well. The lower splitter is installed at the dealer and I think there's 4 or 5 bolts on each side that are R&R's along with all the plastic rivets. I inspected mine before leaving the dealership and had them run it into the service bay and install it with ALL the correct hardware. Half assed dealership techs at their fines, but hey....I used to be that guy when I was working @ my dad's dealership as a kid. LOL

Thanks. Is yours an hp with the dual splitter? Mine is not.

 

[TEAsGrabber]

Thanks. Is yours an hp with the dual splitter? Mine is not.

Yes....then I would guess they were missed during production.

Sponsored