Sponsored

Feels like its dying between 1K-2K

Legionofone

Well-Known Member
Joined
Oct 31, 2015
Threads
21
Messages
384
Reaction score
61
Location
Texas
Vehicle(s)
2016 Mustang GT Base
Hello Everyone!

I have a 2016 mustang GT that is about to drive me insane.

If I am in 4-6th and down between 1K-2K RPM the damn thing SOMETIMES starts to lug and feel like it is missing horribly, it shakes the car forward and backwards.

This is especially bad at 1500 and 1750 RPM

I can't for the life of me figure it out and once it is above 2K the thing runs like a champ!

I do have a lightweight flywheel and dual clutch but this was an issue before then but not as severe.

Anyone have any ideas?
Sponsored

 

highvoltage

Well-Known Member
Joined
Jan 4, 2016
Threads
12
Messages
857
Reaction score
239
Location
NorCal to SoCal
First Name
Brock
Vehicle(s)
24 Mustang GT Atlas Blue, 23 Race Red Bronco
Why would you be in that low RPMs anyways? In 6th I’m below 2k sometimes just cruising on the highway. But if i am gonna be below 2k in any gear i downshift. If in 6th and below 2 k i will normally downshift too unless it’s only for a few seconds. I have a 2016 too. Taken it to the dealer?
 
OP
OP

Legionofone

Well-Known Member
Joined
Oct 31, 2015
Threads
21
Messages
384
Reaction score
61
Location
Texas
Vehicle(s)
2016 Mustang GT Base
I haven't, since I have mods I would prefer not to fight with them and then get charged for something simple.

In my car at least in 6th gear at 60-70 is right in this sweet spot of pain for 6th. I try not to ride her at higher revs if I don't need to.
 

highvoltage

Well-Known Member
Joined
Jan 4, 2016
Threads
12
Messages
857
Reaction score
239
Location
NorCal to SoCal
First Name
Brock
Vehicle(s)
24 Mustang GT Atlas Blue, 23 Race Red Bronco
It’s a coyote it’s meant to rev. Why not rev the car.
 
OP
OP

Legionofone

Well-Known Member
Joined
Oct 31, 2015
Threads
21
Messages
384
Reaction score
61
Location
Texas
Vehicle(s)
2016 Mustang GT Base
Because I like money and reving costs money and increases wear? I dont mind getting on it but sitting at 3K in 5th while driving down the highway at 60 because if I shift to 6th it fucks itself isn't what I call a quality experience...
 

Sponsored

Fredboy

Well-Known Member
Joined
Jul 15, 2016
Threads
4
Messages
96
Reaction score
51
Location
Texas
Vehicle(s)
2004 Camaro Super Sport
You should be in 6th gear when maintaining about 50mph or higher. How much throttle input are you giving when the issue occurs?
 
OP
OP

Legionofone

Well-Known Member
Joined
Oct 31, 2015
Threads
21
Messages
384
Reaction score
61
Location
Texas
Vehicle(s)
2016 Mustang GT Base
@Fred Honestly part throttle any acceleration even maintaining RPM will do it...

[MENTION=21617]mustang1[/MENTION] other than my clutch and flywheel and a catch can yes bone fucking stock.
 

mustang1

Well-Known Member
Joined
Feb 12, 2016
Threads
6
Messages
1,492
Reaction score
267
Location
Dallas, TX
Vehicle(s)
2016 Mustang GT
car always had the issue but got worse with a new clutch ? why did you change the clutch ? no issues in 3rd gear at 1500-1750 ?
 

Xavier

Well-Known Member
Joined
Dec 8, 2015
Threads
15
Messages
337
Reaction score
92
Location
NH
Vehicle(s)
2016 GT
I have 3.31s and I try to avoid using 6th gear unless I'm going over 70 MPH, and even then I'll try my best not to accelerate too much without downshifting. I don't recall experiencing the shaking that you describe though, that's odd.
 

Sponsored

Rebellion

Well-Known Member
Joined
Aug 30, 2016
Threads
14
Messages
1,052
Reaction score
273
Location
Houston
Vehicle(s)
2016 Competition Orange GT
I have always been a notorious "short shifter", too used to diesel engines...and I don't experience that. The ECU and electronic throttle does a pretty good job at keeping you out of lugging most of the time (except in obvious situations, of course).

Is this happening right after shifting or not? It certainly should not be happening in fourth...I would definitely find someone with a similar spec'ed stang locally and swap cars for a brief cruise.
 

soldier989

Well-Known Member
Joined
Mar 26, 2016
Threads
29
Messages
1,129
Reaction score
233
Location
Columbus OH
Vehicle(s)
2017 GTPP Premium
Before storing the GT for the winter, for the 2 weeks I got to drive it, I noticed the car stutters/feels down on power right after shifting into 3rd. I drive through my neighborhood at 7am, and am courteous, so the response of "this engine likes to rev, why would you shift so low" is invalid. It seems to go away when warm.
 
OP
OP

Legionofone

Well-Known Member
Joined
Oct 31, 2015
Threads
21
Messages
384
Reaction score
61
Location
Texas
Vehicle(s)
2016 Mustang GT Base
[MENTION=21617]mustang1[/MENTION] I had a failed throwout bearing, transmission wouldn't shift, put in a mantic clutch which was a huge mistake.

It feels like if you tried to shift to 4th at 10 mph and accelerate just like it is lugging like crazy. I think that the flywheel made it worse by taking away rotating mass on the engine.

I don't notice it much in lower gears because i think they have more torque and I am normally at 2-4K when accelerating. 4th CAN do it but rarely.
 

wildcatgoal

@sirboom_photography
Joined
Feb 8, 2016
Threads
76
Messages
6,589
Reaction score
2,512
Location
USA
Vehicle(s)
TBD
Lightweight flywheel is useless on the street. Need to rev significantly more to maintain rotation of the drivetrain. I got to drive a GT with a lightweight flywheel, it sucked on the street. I suppose it would have been nice on a road course.
 

mustang1

Well-Known Member
Joined
Feb 12, 2016
Threads
6
Messages
1,492
Reaction score
267
Location
Dallas, TX
Vehicle(s)
2016 Mustang GT
what happens if you put cruise control at 60 mph and 6th gear. Lugs and shakes continuously, or just once ?
Sponsored

 
 








Top