BMR SUSPENSION'S S550 Lowering Springs: STANCE PICS!

[Coyote Red]

Texas Floods

Thanks. I'll actually look into these when I get a chance. I'm looking at MPSS in 345. I'll see what my options in the 315 size are.

My precious car I drove around in 305 -555Rs. It would get a little squiggly during rainstorms but I would just drive my truck if I knew ahead of time.

As a fellow Texan I'll lend my experience. Sometimes it rains so hard so fast here the roads will pond or river. "Ponding" on the road make us "wide tire" ponies find a different "lane" near the yellow line, or down near the white line to stay out of the wallowed out "main path" of traffic. This is the best solution I have found in my Texas experience.

Sponsored

 

[AdrianMAK]

First 2018 with BMR SP089 Front, SP082 Rears!

Beat me to it, I was about to post this here.

 

[cjldad]

Your cars look great everybody!
Looking to go a little lower myself.
Any alignment/geometry benefit of using the SP089 on the front vs the SP081?
Thanks!

 

[UWISHU1]

BMR minimal front 275/35/20 BMR drag rear 315/35/20

 

[BmacIL]

Looking fine! Beautiful car.

 

[Stage_3]

Looks killer! Stance is on point.

 

[NoReins]

First 2018 with BMR SP089 Front, SP082 Rears!

would the springs work on a 2018+ with MagneRide? I know over vehicles with MagneRide don't like suspension to be played with.

 

[BmacIL]

would the springs work on a 2018+ with MagneRide? I know over vehicles with MagneRide don't like suspension to be played with.

It would be a good idea to match the spring rates at the least. I don't think we know what the new PP1 and PP1 with mag ride spring rates are, let alone PP2.

 

[BMR Tech]

No. Right now the springs work great on the non MR cars.

Our new GT350 and 18+ Specific MR springs are in development right now.

 

[parajax]

Recently had installed the BMR SP080 on GT convertible.

 

[cjldad]

Any of you running the Ford Performance bump stops with it or just trimming the OE stops?

 

[2morrow]

Any of you running the Ford Performance bump stops with it or just trimming the OE stops?

Mine are trimmed OEM stops.

 

[cjldad]

Purchased a set of 82/89's during the BF sale..

Hope I didn't make a mistake with the 89's and should have got the 81's instead..

 

[BmacIL]

Purchased a set of 82/89's during the BF sale..

Hope I didn't make a mistake with the 89's and should have got the 81's instead..

If you ever go to a square tire setup you'll be happy you did. The wheel gap is perfect and even front to rear with the same diameter tires. A nice consistent circle all around and it looks proper and where it should be, but not slammed. The 081 fronts look best with the smaller PP front tire, IMO. Even with the 089 fronts I've seen dozens with stock tires that look amazing.

 

[Kevin08]

Looks like some 82/89s are in my near future once my car is delivered. Wonder how goofy it will look with the OE 18x8s, they'll probably look completely sucked into the wheel well with that terrible offset they have.

Anyone know the wheel width that 2018 in the image on the previous page had? I am looking to do 19x10 285/35/19 squared.

Sponsored