gram lights 57CRs on 16 GT non-PP

[Jaehead]

Anyone tried to run these wheels?

for 18x9.5 there are et22 and et38 available, I'd be interested in getting the +38 but not sure if the barrel will clear the base 4pot calipers. I'm guessing +22 wouldn't work with stock camber? according to evasive motorsports these wheels will take up to a 15mm stud so no worries there.

Any thoughts?

Sponsored

 

[Paul@PKAUTODESIGN]

Image doesnt work brotha

 

[tyshenry]

Anyone tried to run these wheels?

for 18x9.5 there are et22 and et38 available, I'd be interested in getting the +38 but not sure if the barrel will clear the base 4pot calipers. I'm guessing +22 wouldn't work with stock camber? according to evasive motorsports these wheels will take up to a 15mm stud so no worries there.

Any thoughts?

Those offsets ought to work out with the +38 in the rear and the +22 in the front, but you will end up with almost flush in the front and then less than flush in the rear. Or buy the +38 square and then run ~5mm spacer up front.

 

[Jaehead]

http://imgur.com/a/kCPUi

this link should take you there.

you guys dont think there'll be issues with caliper clearance? really digging the look of these wheels

 

[5LITER]

I like them too. If they fit an Lexus isf maybe they might clear? They have nice concavity.

 

[GetYourWheels]

oooh.. I think the Advan GT would be pretty cool on the S550

What would you end up running on the rear with the 57CR?

 

[Shouldhavegotthegt]

They weren't grams but I had some 19x9.5 STRs with a 38 offset. They were so tucked I bought some 20mm spacers and they were almost flush. I'd run the 22. I've got MMD 20x10 with a 45 offset with 20mm spacers and those are flush. So essentially a 25 offset of 20x10.

 

[Jaehead]

oooh.. I think the Advan GT would be pretty cool on the S550

What would you end up running on the rear with the 57CR?

i was planning on running 18x9.5 et38 square, right now i'm at 19x8.5 et42.5 with 25mm spacers and the rears just slightly poke, seems like 9.5 et38 would be about 7mm tucked compared to that?

i wouldn't mind a et22 as well but i didn't think itd work on stock performance pack camber specs. im also thinking about running 275 size..

They weren't grams but I had some 19x9.5 STRs with a 38 offset. They were so tucked I bought some 20mm spacers and they were almost flush. I'd run the 22. I've got MMD 20x10 with a 45 offset with 20mm spacers and those are flush. So essentially a 25 offset of 20x10.

u got any photos of this setup??

Sponsored