MMD V Spoiler on a Convertible?

[Sunman54]

I've seen pictures of the Foose Rear spoiler on Mustang convertibles but have not seen any of the MMD V on a convertible. Has anyone installed the "V" on a convertible and has pictures or know of a picture link. There are plenty of pictures of on the "V" on a fastback, but not a convertible? Trying to make up my mind which one to buy. Also, why won't a Roush rear spoiler fit on a convertible? Thanks for the assistance.

Sponsored

 

[TheDivaDanielle]

the Roush spoiler won't fit because of where it's located on the car. your third brakelight is also there.

 

[NoReins]

I've seen pictures of the Foose Rear spoiler on Mustang convertibles but have not seen any of the MMD V on a convertible. Has anyone installed the "V" on a convertible and has pictures or know of a picture link. There are plenty of pictures of on the "V" on a fastback, but not a convertible? Trying to make up my mind which one to buy. Also, why won't a Roush rear spoiler fit on a convertible? Thanks for the assistance.

I would recommend keeping an eye on http://mustang6g.com/forums/showthread.php?t=40081&page=12

there is a guy that purchased the V-Series for his convertible.

 

[assclown]

I dried fit it today with a friend, will ask him to post pics on his car (yellow)

It looks incredible on black, can't wait till it gets a tiny bit warmer to put it on. I didn't take any pics of it on black though :(

 

[assclown]

Here you go, dry fit over the blade spoiler in a few pics, and then placed in front of the blade spoiler to show correct height (but not correct front to back offset)

@ toplessfun

 

[TheDivaDanielle]

well it's certainly big.

 

[assclown]

well it's certainly big.

There is no doubt it is in your face.

The rearward visibility is a little blocked; the first bottom line on the defroster is blocked.. say about 15%.

 

[assclown]

Done..

 

[Jeffola]

Maybe the V series is better, It bought and installed the MMD spoiler on my 2015 convertible in January. The fit was good, but the front corners don't hold well to the body. I'm guessing that it's close, but not exactly the same contour. That being said the gaps have opened up since install and there's no ability to tighten further. I called AM today and got the answer that it's normal, acceptable and they will do nothing to remedy the situation. I'm not here looking to bash them, they have been really good in the past. I will replace it with something that should fit better and probably won't buy anything else from them that they make. I know they are a sponsor, I am aware they have some good deals, but for this part to not look perfect AT ANY PRICE means it's not right for me and my mustang. Your mileage may vary.

Sponsored