Steve68
Mr. Robot
- Thread starter
- #31
I wouldn't say 100%. There's still a slight gap there, maybe a 1/16". I'm still going to say the two center "45 degree" M4.2x25 screws are too long. Even pushing the splitter up and in while driving them in, they want to dig in to a portion of the fascia that I don't think they should be. I believe this wants to push the splitter down and away from the fascia lip. I'm thinking that it might be a good idea to try to coerce them to drive up at a little bit steeper angle than they might want to naturally thereby getting them to clear that bit of the fascia tab that they're hitting. That, or get shorter M4.2 screws. 20mm might be too short. I don't know if there's something in between. The key thing is to get that tab near the center to seat in the fascia hole. Bottom line, you can't see the slight gap when standing near the car or at any appreciable distance.
Sponsored
Last edited: