Turn Signal Problem

[blakedanatural]

Hello All,
I need help with solving my left turn signal issue. I replaced my Raxiom sequential smoked turn signal with a new pair because one side was out. I got a new pair {( warranty from AM ). Installed the new ones and when I turn on the lights only the passenger side lights up. But when I push the lever down to turn left only the amber portion of the light works. There must be a short because I see there isn't a fuse for the front turn signals. I put the original ones back on and the same problem is occurring. So it isn't the AM product. Does any one have any idea whats going on? Or is there a way I can test he connectors. Appreciate any help.
Blake

Sponsored

 

[SLLABGIB]

Were you able to figure out what was causing it?

 

[SLLABGIB]

So I found the fault with mine, I hope that it helps with the next person with the same issue with these lights.
So I New the issue had to be a connection problem since the passenger blinker worked but nothing else with the turn signals did. So I put the car up on ramps and started looking at all of the connections. Found that the vampire clips that they supplied were not biting the cable enough to make a good connection. Removed them and just cut the old connections off. (Make sure that you cut them at least 2 inches back incase you ever want to reuse the old lights again. I just snapped them into the old lights so that I don’t lose them). I stripped back the wire and married the new and old together. Soldered then and shrink tubed them. Everything it working fine now. Good luck! Hope this helps!

Sponsored