Troubleshoot Moddiction Unit

[nate154]

Hello all,

I had my unit on before, so I know it works. I soldered my LOC back there; hooked everything back up, and no screen. Amp turns on and speakers work. No music, tho. Unhooked everything and reinstall- still no screen. Checked fuses 32 and 33 by the kick panel and they were good. All the connectors seem to be snug. I don't know what to do. Any help is appreciated.

Only thing I can think of is I used a heating gun for the shrink tubing, but I wasn't dumb with it. Nothing looks damaged, and the loc is working...

Thanks.

Sponsored

 

[nate154]

Anyone know of any fuses I could check? I did find this one blown #54 Auxiliary power point, but that didn't do anything.

I'm beginning to think it is the unit. I'm not sure what could have happened.

 

[nate154]

Well I think I've checked the right wires for power to the screen. The red is constant and that was fine. The ground read at .01 at the lowest ohms setting on the mm. I think the ignition is the white and green wire that comes from the starter relay, but I'm not sure. It's not as easy to check because I can't stick the probe in the harness, but I think it's getting power.

Would this pretty much mean the screen is bad? Does anyone know anything else I need to test?

http://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=1124264 - Wiring diagram.

 

[nate154]

Anyone know of any fuses I could check?

I'm beginning to think it is the unit. I'm not sure what could have happened.

There's a 5 amp fuse connected to the harnesses that came with the screen and that was blown. Problem fixed. Thanks for all the help, though.

Sponsored