Steeda alignment kit

[EeeZy5.0]

What's up everyone. I installed the steeda irs bushings, steeda irs alignment kit, and the steeda irs braces. I was able to get everything on with no problems except for the last sleeve of Alignment kit for the passenger side rear bolt on the subframe. Seems like it's too big for the hole where the subframe bolts go into. Anyone else come across this issue? Is the alignment kit side specific? I'm planning to take them out and switch them around and see if that works. I've searched online and haven't really found anything about this issue.

Sponsored

 

[GilSilcox]

The sleeves are different sizes for the front and rear holes. I did the same thing and found out the hard way. Good luck

 

[jbailer]

Not side specific, just front and back. I just had mine out dropping the IRS again today, no problems.

 

[EeeZy5.0]

Oh ok! Thanks guys for the responses. I'll have to get this done over the week.

Sponsored