Scootsmcgreggor
Well-Known Member
- Thread starter
- #1
In perfect condition, used for 5 track days and removed in between. Driver side.
$300 shipped contiguous US.
$300 shipped contiguous US.
Sponsored
Very easy to install and uninstall for track days. I just installed one on the driver’s seat of my 2019 Bullitt.Is this setup easy to install and then uninstall just for track days?
Was this set in a 2018+? From their website looks like 2017 and older runs a different part number.Yep that’s exactly what it’s for. You install two extra clips into the car (that you can hardly see when the harness is removed) then all 4 belt points clip in and out in less than 1min.
2017 and older harnes can be used in an 18+, but would require sourcing a 2017 and older driver’s seat buckle and rear seat buckle. They’re cheap on eBay.Was this set in a 2018+? From their website looks like 2017 and older runs a different part number.
Are you sure on the drivers buckle? I thought the front buckles were the same?2017 and older harnes can be used in an 18+, but would require sourcing a 2017 and older driver’s seat buckle and rear seat buckle. They’re cheap on eBay.
My bad Scoots and good catch on not needing the driver’s seat buckle. I knew the back one was required and assumed the front was as well.Post #8 confirms that its just the rear buckle that needs swapping:
https://www.mustang6g.com/forums/threads/schroth-quickfit-pro-on-a-2018.115437/
I will ship this harness with a 2015-2017 rear buckle for anyone with an 18+