ScanGauge Tool Message

[DaveJP]

So I have an old ScanGauge tool (at least 15 years old). I wanted to see if it still worked so I connected it to my 350R. It connected fine and started reading some parameters but when I selected Scan option I see the message “no codes found - not ready“. Manual says that this means my car is not ready for emissions testing since last reset/ battery disconnect but I have never had the battery disconnected or have I reset anything since I bought the car new (2019). It has never been back to the dealer for anything so I know it has never gone through a reset. Any ideas…??

Thanks,
Dave

Sponsored