PNR Trunk Mount Ice Tank

[compslow]

I’m looking for a little advice on how to run the wiring for my PNR ice tank pump. I’ve searched for this but haven’t found a write up on an S550. The kit came with a relay with 4 wires. Where did everyone run their wires? As you can tell, I’m not technically savvy when it comes to wiring so I was just hoping for some direction on this to make the install go quickly. I’m currently installing this along with my 2.9 Whipple and Fore Fuel system.

Sponsored

 

[brucelinc]

I don't know if this will help or not. I asked PNR the same question and this is what they sent me. I haven't gotten a kit yet so I have no personal experience.

· Red wire is number 35 on relay and goes direct to battery 12v.

· Black wire is number 85 and that goes to a ground. (clean metal surface with no paint).

· Blue wire is number 87 and that goes to the intercooler pump. Rule pump brown wire, or Davies Craig 150 blue wire. The black wire on the pump is (- ground).

· White wire is number 86 and that is your trigger wire. That will be wired to a 12v key on with a optional switch in between. This will turn the pump on with the car runing. If used at drag strip, its recommended to use a switch in between to keep the ice water from flowing until after you do your burnout. Then you will have the coldest water right when needed during the pass.