PID for ignition correction on each/all cylinders?

[Heggs550]

I found the spreadsheet of PIDs and already have the Ford PIDs enabled in my Torque app, but the only option for ignition correction I see is on the spreadsheet and only addresses cylinder 1. Is there a change to the PID I can make for 2-4 as well? My OAR is typically solid at -1, but the knock sensor/counter in the Torque app shows a solid 1 while WOT and goes back to zero after letting off. Not too worried about it, but I expected that it would keep count rather than just display 1 and I'd like to check out the ignition corrections as well.

Sponsored