Ninjavitis
Well-Known Member
- Thread starter
- #1
I had a few questions regarding pulley swap from 3.8 to 3.6 for the Paxton 2200SL.
I installed the kit last winter and it has been running great on the 3.8" since, I am having a bit of issue with lower end torque and am looking to get a little more power out of it.
I am running on 93 with zero positive knock under load even in 90 degree heat (usually dips to -4 and stays around there WOT). I have been logging a lot of runs the past week in the heat to monitor the tune and make sure it's holding in there (tuned originally around 40F) and it seems stable enough to throw a little more at it.
My question is, other than the 3.6" pulley, what else do I need for the install? Do I need to relocate the idler pulley or get a new belt for the 3.6? I have the belt that Paxton supplies with the kit (Do not remember length).
Thank you!
I installed the kit last winter and it has been running great on the 3.8" since, I am having a bit of issue with lower end torque and am looking to get a little more power out of it.
I am running on 93 with zero positive knock under load even in 90 degree heat (usually dips to -4 and stays around there WOT). I have been logging a lot of runs the past week in the heat to monitor the tune and make sure it's holding in there (tuned originally around 40F) and it seems stable enough to throw a little more at it.
My question is, other than the 3.6" pulley, what else do I need for the install? Do I need to relocate the idler pulley or get a new belt for the 3.6? I have the belt that Paxton supplies with the kit (Do not remember length).
Thank you!
Sponsored