olaosunt
Well-Known Member
- Thread starter
- #1
I have 7 good used pistons out a failed alluminator block and a brand new one that replaced the one that had a hole .
Engine builder said the used ones all checked out and I was going to use them to build a “spare” but turns out the “replacement “ Mahle had sent me was actually .005 over bore .
Engine builder had said he could still use them in my sleeved block by going overbore on the one cylinder but I decided to use another set of Manley pistons instead .
Not sure what they are worth to be honest but if would guess $400 bucks .
If I am way off let me know .
I am not going to ever use them again so I am open to all offers .
Engine builder said the used ones all checked out and I was going to use them to build a “spare” but turns out the “replacement “ Mahle had sent me was actually .005 over bore .
Engine builder had said he could still use them in my sleeved block by going overbore on the one cylinder but I decided to use another set of Manley pistons instead .
Not sure what they are worth to be honest but if would guess $400 bucks .
If I am way off let me know .
I am not going to ever use them again so I am open to all offers .
Sponsored
