Launching problem 18 whippled

[95 marty]

I have an 18 whippled 10a stage 11. Took it to the track for the first time. Turned off adv traction control but while doing a burnout I lost power. Then when I got to the line, I left around 1700 rpms then lost power again. What do you think is going on? I did go 10.7 with no burnout and leaving at idle. Would of liked to get a better run.

Sponsored

 

[18 Smoke]

I have an 18 whippled 10a stage 11. Took it to the track for the first time. Turned off adv traction control but while doing a burnout I lost power. Then when I got to the line, I left around 1700 rpms then lost power again. What do you think is going on? I did go 10.7 with no burnout and leaving at idle. Would of liked to get a better run.

Did it go into limp mode? P2119 code?

 

[95 marty]

No codes ever showed up

 

[TLW1022]

Sounds like Launch Control is on
When I put mine in Track mode, Launch Control comes on automatically

 

[armykyle1 [HACKED ACCOUNT]

If you changed drive modes after turning advanced track off, it comes back on.

Change drive modes, advanced track off, line lock, then go.

 

[Face]

Sounds like Advance Trac is still messing with you. You could always disconnect the plug on the inside of the engine bay nearest the airbox on the driver side if you want to totally eliminate the possibility of advanced trac kicking on.

Sponsored