INSTALLATION OEM PARK AID

[asci01]

When drilling the holes, don't put pressure on your drill and use a variable speed drill. Use the lowest speed. The plastic of the bumper is very soft, so the drill bit will have no problem cutting a hole. As you know, you can always make the hole bigger but it's very hard to make it smaller if you cut too much.

When programming PAM 736-01-01, use '5' on the 3rd digit if you have an automatic, otherwise use '4"

Sponsored

 

[asci01]

By the way, all the sensors are the same so it doesn't matter which one you decide to use for each location as long as you turn them in the correct direction when installed and keep the polarity pins the same.

If you switch the polarity, you'll get an 'internal sensor failure' on forscan and if ANY one sensor fails or is not connected correctly, the whole parking aid system will shut down and will not provide any warnings whatsoever.