Headers fitting into catback issue

[4leghorse]

18+ AWE touring catback has a 2.5 inlet neck down to factory headers. Stainless power has long lead 3" headers that I want to get but they wont fit into the 2.5 awe. Idk if previous awe catbacks had the 2.5 neckdown but how did you fit your headers on them. I guess cut the inlet and connect the 3" headers that way?

Sponsored

 

[Andrew@Lethal]

18+ AWE touring catback has a 2.5 inlet neck down to factory headers. Stainless power has long lead 3" headers that I want to get but they wont fit into the 2.5 awe. Idk if previous awe catbacks had the 2.5 neckdown but how did you fit your headers on them. I guess cut the inlet and connect the 3" headers that way?

You would need factory connect connection pipes OR you can cut and weld a reducer on the ends of the connection pipes.

 

[4leghorse]

You would need factory connect connection pipes OR you can cut and weld a reducer on the ends of the connection pipes.

Cool thanks

 

[CorvZ061]

I’d cut the reducer off the cat back and just connect the catback directly to the 3” extension pipes because the catback is 3” pas the factory connection points, right?

Sponsored