Harness Bar?

[SchultzLT1]

Does anybody know if there is a bolt in harness bar available for the gt350 yet? I want to have w harness for the next DE, but I don't want to do any welding or drilling for a cage.

Sponsored

 

[nastang87xx]

I've been looking out for this too...

 

[krt22]

I believe I read on TMO that cortex is working on one

 

[nastang87xx]

Noice, I'll be on the look out.

 

[Super Werty]

Watson racing has a bolt in 4 pt cage ready for harness. And it uses factory holes... No drilling. I plan on buying eventually

 

[R 350 gt Donson]

Watson racing has a bolt in 4 pt cage ready for harness. And it uses factory holes... No drilling. I plan on buying eventually

I bought this last week and is scheduled to be installed in my R next wed I will post photos after install.

 

[RoadRacer]

Cool Tech makes a nice 4-pt bolt in roll bar as well. Very happy with the fit-n-finish.

 

[FPCV8YO]

I bought this last week and is scheduled to be installed in my R next wed I will post photos after install.

Did you go red?

 

[krt22]

Watson racing has a bolt in 4 pt cage ready for harness. And it uses factory holes... No drilling. I plan on buying eventually

Not 100% true, there is definitely drilling involved, no more or less than any other bolt in bar. Watson's bar seems like the best bang for the buck however

 

[CSL]

Does anybody know if there is a bolt in harness bar available for the gt350 yet? I want to have w harness for the next DE, but I don't want to do any welding or drilling for a cage.

If you are just looking for the benefit of a harness you can buy a schroth 4 point that tethers into rear seat anchors that will feed through the Recaros.

 

[SchultzLT1]

If you are just looking for the benefit of a harness you can buy a schroth 4 point that tethers into rear seat anchors that will feed through the Recaros.

I have the tech seats and I've been reading that may not be the best choice. Does anybody have any input on that harness?

 

[snaproll]

Without a roll bar I would think carefully about using 4, 5 or 6 point harnesses. If you roll the car you could be in much worse shape than with a 3 point stock setup. I'm all for safety but don't believe a harness bar is the way to do it.

 

[SchultzLT1]

Watson racing has a bolt in 4 pt cage ready for harness. And it uses factory holes... No drilling. I plan on buying eventually

I just read about it and there is in fact quite a bit of drilling and trimming necessary.

 

[Steve68]

I think the cool tech is what they have in the Track Attack cars. Can anyone confirm this?

Looks like the Watson requires rear seat delete while the cooltech does not. Not that the seats are useful before or after the roll bar install.

 

[krt22]

I think the cool tech is what they have in the Track Attack cars. Can anyone confirm this?

They are watson bars. Watson makes the cages for the factory race cars so it makes a lot of sense. Another reason I will be using Watson if I get one

Sponsored