Do you have any pics of it? How about a link to the one you got?I ordered a carbon fiber spoiler off ebay for $200.... Best decision I've ever made!! The finish was amazing and at this point I dont care if it's real carbon fiber or not, it's impeccable..!
I didn't even think about them being ABS thanks for pointing that out MrVu. I personally think plastic is fine (especially at the sub $300 price point) as long as it is finished fairly nicely. In my mind its just one material vs another and each has their own opinions. I did get some the MMD rear louvers which are ABS and it does feel a bit flimsy. I'm curious how thick the Ebay wings are because if they actually were shaped in a way that created down force I would be borderline worried about it snapping in half at highway speeds if they were too thin.
I'm hoping someone here has already been a guinea pig on the matter though.
MrVu did you find a wing that is stick on only? I have only seen maybe one of those and it was just a lip. Sounds like you have a nice build going. I wasn't planning to swap body panels (except maybe the deck-lid panel), until my warranty was gone/ i had a lot more paint chips. I'll be looking out for some build photos of yours though!Definitely! Don't get me wrong, if it's the right solution for you, then by no means would I want to dissuade you from a purchase. In my case, I'm currently swapping the front bumper, front valence, rear valence, and side skirts to fiberglass/carbon replacement, so the eBay solution would put back plastic while there is none anywhere else on the exterior. Also, I currently have no holes in my trunk as I got the PP, and I didn't want to marry myself to a plastic solution that requires drilling. I got myself a fiberglass wing instead.
I'd also love to see pics of the wing on a car if anyone in here does decide to pull the trigger!