Faulty nGauge prevent my car from starting

[johani]

Hi
My nGauge suddenly after starting the car i got the wrench icon on the screen and the hill start warning then the car just turned off and wouldnt start again the dashboard was off the remote wasn't working anymore no radio no crank the car just went f**n weird, i tried everything all the fuses were good nothing was damaged , i finally decided to disconnect the ngauge and the car came back to live with no code .
i tried the hp MPVI2 to check the OBD plug and it was fine no problem.
to verify i plugged the nGauge again and vola the car went crazy and the engine off i had IBS, diff lock and the wrench icon again , so yeah the ngauge is faulty and dangerous.

.

Sponsored

 

[Cobra Jet]

Check the small harness that goes to the Ngauge - they are prone to failure. There were older threads on here where there was a source for replacement Ngauge harnesses.

 

[johani]

thank you for replying .
i use this cable only from plug to nGage
thx

 

[Cobra Jet]

thank you for replying .
i use this cable only from plug to nGage
thx

No problem. Here’s the thread I was referencing in case it’s your cable causing the issue between the car and the gauge…. Read through to page 2.

https://www.mustang6g.com/forums/threads/im-looking-for-ngauge-cable.182653/

 

[johani]

No problem. Here’s the thread I was referencing in case it’s your cable causing the issue between the car and the gauge…. Read through to page 2.

https://www.mustang6g.com/forums/threads/im-looking-for-ngauge-cable.182653/

THANK YOU

Sponsored